DNDNS-200 Exam - Free Dell Questions and Answers

Question #11 (Topic: )

The status LED is blinking RED for an N-Series switch.
Which system behavior is indicated?

A. The switch is booting. B. A noncritical system error has occurred. C. Normal operation is occurring. D. A critical system error has occurred.

Answer: B

Question #12 (Topic: )

Which three cabling items should be considered when stacking N4000 Series switches?
(Choose three.)

A. Use interfaces with the same bandwidth between stack members. B. Use a cascade topology for redundancy between stack members. C. A QSFP+ breakout cable cannot be used for stacking between members. D. Ports from an installed expansion module are not supported with stacking. E. A QSFP+ port should be counted as a single port when used for stacking. F. Up to eight ports may be used on any switch for stacking purposes.

Answer: A,E,F

Question #13 (Topic: )

[Dell-DNDNS-200-7.0/Dell-DNDNS-200-11_2.png]
Refer to the exhibit.
Considering the network topology and information shown, what is an issue with end point
devices in network 192.168.102.0/24 that try to route to 192.168.101.0/24?

A. ICMP Redirects B. Suboptimal Routing C. Routing Loop D. Summarization Black Hole

Answer: C

Question #14 (Topic: )

Which two commands are required to configure OSPFv2 on N-Series? (Choose two.)

A. router-id ipv4-address B. router id ipv6-address C. ip ospf enable D. router ospf [process id] E. ip ospf priority number-value

Answer: A,D

Question #15 (Topic: )

Which three properties are required for two OSPF router interfaces to establish a neighbor
relationship? (Choose three.)

A. Router interfaces must have the same OSPF timers. B. Router interfaces must be on a point-to-point network. C. Router interfaces must be in the same area. D. Router interfaces must use the same OSPF process I E. Router interfaces must be on the same primary IP subnet.

Answer: A,C,E

Dell DNDNS-200 - Dell Networking Professional Exam