Dell DNDNS-200 - Dell Networking Professional Exam
Page: 2 / 12
Total 60 questions
Question #6 (Topic: )
[Dell-DNDNS-200-7.0/Dell-DNDNS-200-5_2.png]
Refer to the exhibit.
Two S-Series switches are configured as a VLT pair. The output from the first peer switch
is as shown.
Which three results can be determined based on the output shown? (Choose three.)
Refer to the exhibit.
Two S-Series switches are configured as a VLT pair. The output from the first peer switch
is as shown.
Which three results can be determined based on the output shown? (Choose three.)
A. The command back-up destination command has been applied but there is no IP- reachability for Backup-Link connectivity between Peers.
B. VLTs downstream to other devices will not form because the versions are the same for both VLT peers.
C. The domain ID was automatically created based on the System MA.
D. The VLTi peer-link has not been created between the two VLT peers.
E. The System Mac was statically defined by an administrator, and all downstream switches only see this MAC address.
F. The restoration of VLT ports after a system has been rebooted has been manually configured.
Answer: A,E,F
Question #7 (Topic: )
When facing the front of a C-Series switch, in which direction does air flow?
A. from the right side to left side
B. from the front side to back side
C. from the back side to front side
D. from the left side to right side
Answer: A
Question #8 (Topic: )
A networking engineer needs to configure several VLANs for S-Series switches for both
Untagged and Tagged traffic.
Which three of the following apply? (Choose three.)
Untagged and Tagged traffic.
Which three of the following apply? (Choose three.)
A. A Tagged interface can only be a member of a single Tagged VLAN.
B. A Tagged interface can be a member of multiple VLANs.
C. Hybrid ports can be assigned to both an Untagged VLAN and Tagged VLAN.
D. When a Tagged interface is removed from a VLAN, it will always be placed in the default VLAN as a Tagged interface.
E. Hybrid ports can be assigned to multiple VLANs but not the default VLAN.
F. When a Tagged interface is removed from a VLAN, it will remain Tagged only if it is Tagged in another VLAN.
Answer: B,C,F
Question #9 (Topic: )
A network engineer needs to make sure that the first 16 switchports on an S-Series switch
are enabled for immediate forwarding when a computer or server is connected. The ports
must be shut down if a switch with default configuration is connected. The S-Series switch
is already configured for IEEE 802.1w.
Which commands meet the requirements for the switchports?
are enabled for immediate forwarding when a computer or server is connected. The ports
must be shut down if a switch with default configuration is connected. The S-Series switch
is already configured for IEEE 802.1w.
Which commands meet the requirements for the switchports?
A.
B.
C.
D.
Answer: B
Question #10 (Topic: )
Two Dell S-Series Switches are directly connected.
[Dell-DNDNS-200-7.0/Dell-DNDNS-200-8_2.png]
[Dell-DNDNS-200-7.0/Dell-DNDNS-200-9_2.png]
Which statement describes what will happen when a ping is sent from Dell-1 to Dell-2?
[Dell-DNDNS-200-7.0/Dell-DNDNS-200-8_2.png]
[Dell-DNDNS-200-7.0/Dell-DNDNS-200-9_2.png]
Which statement describes what will happen when a ping is sent from Dell-1 to Dell-2?
A. Ping will not work because of MTU Mismatch.
B. Ping will not work because of IP Network Mismatch.
C. LLDP shows 0/37 is connected to 0/39 and pings will be successful.
D. Link is Operationally up; therefore, pings will work.
Answer: B
