Juniper JN0-360 - Juniper Networks Certified Internet Specialist SP (JNCIS-SP) Exam
Page: 3 / 96
Total 477 questions
Question #11 (Topic: Volume A)
What are two characteristics of load-balancing implementation on a Junos device? (Choose two.)
A. It balances packets on a per-packet basis.
B. It balances packets on a per-flow basis.
C. It is enabled through a policy.
D. It is enabled by default.
Answer: BC
Question #12 (Topic: Volume A)
A network administrator has been asked to configure the most specific aggregate route to summarize the four specific prefixes shown below:
10. .5.0/24
10. .12.0/24
10. .17.0/24
10. .21.0/24
Which configuration completes this task?
10. .5.0/24
10. .12.0/24
10. .17.0/24
10. .21.0/24
Which configuration completes this task?
A. [edit routing-options] user@router# show aggregate { route 10. .0.0/19; }
B. [edit routing-options] user@router# show aggregate { route 10. .0.0/20; }
C. [edit routing-options] user@router# show aggregate { route 10. .0.0/21; }
D. [edit routing-options] user@router# show aggregate { route 10. .0.0/18; }
Answer: A
Question #13 (Topic: Volume A)
Which statement correctly describes unified in-service software upgrades (ISSU)?
A. Unified ISSU is built upon graceful-restart extensions to allow upgrades with no impact to the data plane.
B. Unified ISSU is supported on systems with single or dual Routing Engines.
C. Unified ISSU permits both upgrades and downgrades with no control plane disruption and is based on the graceful Routing Engine switchover (GRES) feature.
D. Unified ISSU is based on nonstop-routing (NSR) and graceful Routing Engine switchover (GRES), and permits software upgrades only.
Answer: D
Question #14 (Topic: Volume A)
R0 is a Juniper Networks MX router with dual Routing Engines. You must load new software on R0 while ensuring no control plane disruption and minimal data
loss.
Which three features meet the requirement? (Choose three.)
loss.
Which three features meet the requirement? (Choose three.)
A. graceful restart
B. NSR
C. graceful Routing-Engine switchover (GRES)
D. unified ISSU
E. BFD
Answer: BCD
Question #15 (Topic: Volume A)
What are two ways that nonstop routing works? (Choose two.)
A. by enabling redundant REs to switch from primary RE to backup RE
B. by alerting peer nodes of any routing table changes
C. by enabling redundant REs to run a different version of the Junos OS
D. by replicating routing protocol information
Answer: AD
