HP HP0-Y52 - Applying HP FlexNetwork Fundamentals Exam
Page: 3 / 24
Total 116 questions
Question #11 (Topic: )
Refer to the exhibit.
[HP-HP0-Y52-8.0/HP-HP0-Y52-7_2.png]
A network administrator is upgrading the operating system on an HP Comware switch.
When copying the new image from a TFTP server to the flash of the switch, the process
fails because there is not enough flash to store the new operating system. The new
operating system is 3.2MB in size. The administrator then executes the commands shown
in the exhibit above.
Which action should the administrator perform to solve this problem?
[HP-HP0-Y52-8.0/HP-HP0-Y52-7_2.png]
A network administrator is upgrading the operating system on an HP Comware switch.
When copying the new image from a TFTP server to the flash of the switch, the process
fails because there is not enough flash to store the new operating system. The new
operating system is 3.2MB in size. The administrator then executes the commands shown
in the exhibit above.
Which action should the administrator perform to solve this problem?
A. Execute the reset recycle-bin command, and perform the TFTP transfer again.
B. Execute the clear flash command, and perform the TFTP transfer again.
C. Reformat flash, and perform the TFTP transfer again.
D. Execute the delete old.app command, and perform the TFTP transfer again.
Answer: A
Question #12 (Topic: )
Which settings enable a network administrator to use terminal emulation software to
interface with an HP Comware switchs auxiliary port?
interface with an HP Comware switchs auxiliary port?
A. 9600 bps, 7 data bits, 1 stop bit, no parity, flow control
B. 14,200 bps, 8 data bits, 1 stop bit, parity, flow control
C. 9600 bps, 8 data bits, 1 stop bit, no parity, no flow control
D. 9600 bps, 8 data bits, 1 stop bit, parity, flow control
Answer: C
Question #13 (Topic: )
Which statement is true about the default configuration on an HP ProVision switch?
A. Spanning tree is disabled.
B. LACP is used when a BAGG interface is created.
C. IRF is enabled.
D. RSTP is the default spanning tree mode.
Answer: A
Question #14 (Topic: )
A customer is implementing a network using HP ProVision switches. Which default setting
applies to the ProVision switches?
applies to the ProVision switches?
A. All ports are disabled.
B. Routing is enabled.
C. Telnet is enabled.
D. A static IP address is assigned to VLAN 1.
Answer: C
Question #15 (Topic: )
What is the purpose of a management VLAN on an HP Provision switch?
A. To prevent IP addresses from being configured on any VLANs other than the management VLAN
B. To provide an administrative-only marker, label, or alias for the VLAN where IMC is installed
C. To identify a specific VLAN as the only VLAN from which users can connect to the switch management interface
D. To limit remote access connections by specifying the IP addresses that can establish connections
Answer: C
