Dell DES-5221 - Specialist - Implementation Engineer, Data Center Networking Exam
Page: 3 / 12
Total 60 questions
Question #11 (Topic: Topic 1)
Using the MAC 8c-ec-4b-5b-61-9d, what is a valid EUI-64 link local address?
A. 2001::a9:8eec:4bff:fc5b:619d
B. fe80::a9:8cec:4bff:fe5b:619d
C. ff80:a9:8eec:4bff:fe5b:619d
D. fe80::a9:8eec:4bff:fe5b:619d
Answer: B
Question #12 (Topic: Topic 1)
A network administrator is designing a Layer 2 topology and requires separate spanning-tree roots to avoid having a given port blocked for all instances. Which
spanning-tree protocols will meet this need?
spanning-tree protocols will meet this need?
A. STP & RSTP
B. RSTP-PV & MSTP
C. STP & RSTP-PV
D. RSTP & MSTP
Answer: B
Question #13 (Topic: Topic 1)
[Dell-DES-5221-1.0/xmlfile-7_1.png]
Refer to the exhibit.
Which configuration will allow S1 to ping S2’s Lo0 address?
Refer to the exhibit.
Which configuration will allow S1 to ping S2’s Lo0 address?
A. S1(config-router)# ip route 144.254.32.1 192.168.32.2/32
B. S1(config-router)# ip route 192.168.32.2 144.254.32.1/32
C. S1(config)# ip route 144.254.32.1/32 192.168.32.2
D. S1(config)# ip route 192.168.32.2 144.254.32.1/32
Answer: C
Question #14 (Topic: Topic 1)
The network administrator wants to configure RADIUS authentication for VTY access, and for console access to use the local configuration. Which two commands
should be used to achieve this goal?
should be used to achieve this goal?
A. aaa authentication login vty group radius aaa authentication login console local
B. aaa authentication login default group radius aaa authentication login console local
C. aaa authentication login vty radius aaa authentication login console group local
D. aaa authentication login default group radius aaa authentication login console group local
Answer: B
Question #15 (Topic: Topic 1)
There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error
message is generated. What is the correct action to resolve the issue?
message is generated. What is the correct action to resolve the issue?
A. Verify the VLT LAG ID is configured correctly on both VLT peers.
B. Enable RSTP on both VLT peers.
C. Use the show VLT detail and show VLT brief commands to view the VLT port channel status information.
D. Perform a mismatch check after the VLT peer is established.
Answer: D
