IBM C9010-022 - IBM AIX Administration V1 Exam
Page: 2 / 52
Total 258 questions
Question #6 (Topic: Topic 1)
A system dump has been initiated on an LPAR and LED code "0c1" is displayed, indicating
an I/O error. Where can the administrator find out more about this error?
an I/O error. Where can the administrator find out more about this error?
A. The HMC Service Guide
B. The AIX Version 7.1 Commands Reference
C. HMC Event Log
D. IBM's Fix Central under Power Systems LED support page
Answer: D
Question #7 (Topic: Topic 1)
Which configuration will provide an LPAR maximum network resilience and performance
with two Ethernet adapters?
with two Ethernet adapters?
A. Configure both Ethernet adapters as IEEE 802.3ad link Aggregated with src_dst_port mode
B. Configure EtherChannel using Internet Protocol over InfiniBand (IPoIB) with 64K TCP/IP MTU 64K Superpacket
C. Configure EtherChannel with one Ethernet adapter as primary adapter & one as backup with hash mode roundrobin
D. Configure both adapters with Quality of Server (QoS) adapters and configure virtual IP address on interfaces
Answer: A
Question #8 (Topic: Topic 1)
Which command will display the time and date of the last boot?
A. who-b
B. last-b
C. boot-b
D. time-x
Answer: A
Question #9 (Topic: Topic 1)
What is the difference between deferred and concurrent firmware updates?
A. Deferred firmware can be applied concurrently but contains updates that affect the internal program load path, which are not activated until the next time the server is shut down and restarted.
B. Concurrent firmware must be done on all LPARs in the frame at the same time. Deferred firmware can be loaded on each LPAR at a different time and only becomes active when the LPAR is shutdown and restarted.
C. Deferred firmware can only be applied during an outage to the managed system as it will automatically shut the managed system down during its installation.
D. Concurrent firmware is only for minor fixes to the system mircocode while deferred firmware contains major fixes to the service processor.
Answer: A
Question #10 (Topic: Topic 1)
An administrator wants to create a filesystem with a specific logical volume name, disk
location, and disk placement. Which pair of commandswill allow these attributes to be set
during filesystem creation?
location, and disk placement. Which pair of commandswill allow these attributes to be set
during filesystem creation?
A. crfs followed by chvg
B. crlv followed by mkfs
C. mkfs followed by chfs
D. mklv followed by crfs
Answer: D
