300-320 Exam - Free Cisco Questions and Answers

Question #11 (Topic: Topic 1)

What is the correct state between two BGP peers that are neighbors?

A. active B. operational C. established D. up

Answer: C

Question #12 (Topic: Topic 1)

Refer to the exhibit. A network engineer manually reconfigures the BGP configuration on newly upgraded router R1. However, the BGP neighbor relationship does
not come up with the directly connected neighbor router. What is causing the failure of the BGP neighbor relationship between routers R1 and R2?
[Cisco-300-320-1.0/xmlfile-7_1.png]

A. An incorrect neighbor IP address for router R2 is configured on router R1. B. An incorrect neighbor AS number is configured on router R1 for router R2. C. The wrong BGP authentication password is configured on router R1. D. Router R1 must configure the R2 loopback address as the neighbor IP address.

Answer: C

Question #13 (Topic: Topic 1)

Which option is a primary requirement for the deployment of an IPv6-enabled network via the native method (dual-stack model) within the enterprise campus
environment?

A. hardware-based switching support for IPv6 forwarding on all campus switches B. restriction of IPv6-enabled devices to the core layer C. manual implementation of tunneling between IPv6-incompatible devices in an IPv4-over-IPv6 tunnel D. disabling of multicast in the distribution layer prior to implementation of IPv6

Answer: A

Question #14 (Topic: Topic 1)

Which multicast address must be available for FHRP advertisements in a multivendor environment?

A. 224.0.0.9 B. 224.0.0.18 C. 224.0.0.102 D. 224.0.0.2

Answer: B

Question #15 (Topic: Topic 1)

Which feature must be configured for the VRRP-enabled router to regain the master VRRP status upon recovery from a failure?

A. priority B. authentication C. pre-emption D. Stateful Switchover

Answer: C

Cisco 300-320 - Designing Cisco Network Service Architectures Exam