Palo Alto Networks PCSFE - Palo Alto Networks Certified Software Firewall Engineer Exam
Page: 3 / 25
Total 125 questions
Question #11 (Topic: Exam A)
Which protocol is used for communicating between VM-Series firewalls and a gateway load balancer in Amazon Web Services (AWS)?
A. VRLAN
B. Geneve
C. GRE
D. VMLAN
Answer: B
Question #12 (Topic: Exam A)
Which two elements of the Palo Alto Networks platform architecture enable security orchestration in a software-defined network (SDN)? (Choose two.)
A. Full set of APIs enabling programmatic control of policy and configuration
B. VXLAN support for network-layer abstraction
C. Dynamic Address Groups to adapt Security policies dynamically
D. NVGRE support for advanced VLAN integration
Answer: AC
Question #13 (Topic: Exam A)
Which component scans for threats in allowed traffic?
A. Intelligent Traffic Offload
B. TLS decryption
C. Security profiles
D. NAT
Answer: C
Question #14 (Topic: Exam A)
Which two deployment modes of VM-Series firewalls are supported across NSX-T? (Choose two.)
A. Prism Central
B. Bootstrap
C. Service Cluster
D. Host-based
Answer: BC
Question #15 (Topic: Exam A)
A customer in a VMware ESXi environment wants to add a VM-Series firewall and partition an existing group of virtual machines (VMs) in the same subnet into two groups. One group requires no additional security, but the second group requires substantially more security.
How can this partition be accomplished without editing the IP addresses or the default gateways of any of the guest VMs?
How can this partition be accomplished without editing the IP addresses or the default gateways of any of the guest VMs?
A. Edit the IP address of all of the affected VMs.
B. Create a new virtual switch and use the VM-Series firewall to separate virtual switches using virtual wire mode. Then move the guests that require more security into the new virtual switch.
C. Create a Layer 3 interface in the same subnet as the VMs and then configure proxy Address Resolution Protocol (ARP).
D. Send the VLAN out of the virtual environment into a hardware Palo Alto Networks firewall in Layer 3 mode. Use the same IP address as the old default gateway, then delete it.
Answer: B
