Fortinet NSE7_SDW-6.4 - Fortinet NSE 7 - SD-WAN 6.4 Exam
Page: 2 / 17
Total 81 questions
Question #6 (Topic: Single Topic)
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
A. diagnose sys virtual-wan-link route-tag-list.
B. diagnose sys virtual-wan-link service.
C. diagnose sys virtual-wan-link member.
D. diagnose sys virtual-wan-link neighbor.
Answer: C
Question #7 (Topic: Single Topic)
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
A. Port1 became dead because no traffic was offload through the egress of port1.
B. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
C. Both SD-WAN member interfaces have used separate SLA targets.
D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Answer: D
Question #8 (Topic: Single Topic)
Which statement is correct about the SD-WAN and ADVPN?
A. Spoke support dynamic VPN as a static interface.
B. Dynamic VPN is not supported as an SD-WAN interface.
C. ADVPN interface can be a member of SD-WAN interface.
D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: C
Question #9 (Topic: Single Topic)
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two.)
A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
B. FEC transmits the original payload in full to recover the error in transmission.
C. FEC transmits additional packets as redundant data to the remote device.
D. FEC improves reliability, which overcomes adverse WAN conditions such as noisy links.
E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss.
Answer: CD
Question #10 (Topic: Single Topic)
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
A. All the existing sessions that do not use SNAT will be flushed and routed through port1.
B. All the existing sessions will continue to use port2, and new sessions will use port1.
C. All the existing sessions using SNAT will be flushed and routed through port1.
D. All the existing sessions will be blocked from using port1 and port2.
Answer: BC
