Fortinet NSE7_EFW-7.0 - NSE 7 - Enterprise Firewall 7.0 Exam
Page: 3 / 12
Total 60 questions
Question #11 (Topic: Exam A)
Refer to the exhibit, which shows partial outputs from two routing debug commands.
Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?
Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?
A. Set the priority of the static default route using port1 to 10.
B. Set the priority of the static default route using port2 to 1.
C. Set preserve-session-route to enable.
D. Set snat-route-change to enable.
Answer: B
Question #12 (Topic: Exam A)
Refer to the exhibit, which shows a partial routing table.
Assuming all the appropriate firewall policies are configured, what two changes would an administrator need to make if they wanted to send traffic from a client directly connected to port3, to a server directly connected to port4? (Choose two.)
Assuming all the appropriate firewall policies are configured, what two changes would an administrator need to make if they wanted to send traffic from a client directly connected to port3, to a server directly connected to port4? (Choose two.)
A. Configure route leaking between VRF 12 and VRF 21.
B. Disable auto-asic-offload as this is not supported between VRF instances.
C. Configure RIPv2 to exchange route information between the VRF instances.
D. Configure route leaking between port3 and port4.
E. Enable SNAT on the relevant firewall policies to prevent RPF check drops.
Answer: AC
Question #13 (Topic: Exam A)
What is the diagnose test application ipsmenitor 5 command used for?
A. To enable IPS bypass mode
B. To disable the IPS engine
C. To restart all IPS engines and monitors
D. To provide information regarding IPS sessions
Answer: D
Question #14 (Topic: Exam A)
An administrator has configured two FortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device.
What can the administrator do to fix this problem?
What can the administrator do to fix this problem?
A. Configure remote link monitoring to detect an issue in the forwarding path.
B. Configure set send-garp-on-failover enable under config system ha on both cluster members.
C. Verify that the speed and duplex settings match between the FortiGate interfaces and the connected switch ports.
D. Configure set link-failed-signal enable under config system ha on both cluster members.
Answer: B
Question #15 (Topic: Exam A)
Which statement about IKE and IKE NAT-T is true?
A. IKE is used to encapsulate ESP traffic in some situations, and IKE NAT-T is used only when the local FortiGate is using NAT on the IPsec interface.
B. IKE is the standard implementation for IKEv1 and IKE NAT-T is an extension added in IKEv2.
C. They both use UDP as their transport protocol and the port number is configurable.
D. They each use their own IP protocol number.
Answer: B
