Netapp NS0-194 - NetApp Certified Support Engineer Exam
Page: 2 / 12
Total 60 questions
Question #6 (Topic: Single Topic)
What are two reasons to use VLANs in a NetApp storage solution? (Choose two.)
A. to isolate UDP traffic from TCP traffic
B. to isolate management traffic from other IP traffic
C. to isolate iSCSI traffic from NAS traffic
D. to isolate FC traffic from other IP traffic
Answer: AC
Question #7 (Topic: Single Topic)
Which CIFS server configuration determines the domain controllers that a CIFS server uses?
A. site membership
B. enabled SMB versions
C. trusted domains
D. discovery mode
Answer: A
Question #8 (Topic: Single Topic)
Which three techniques are used in ONTAP to improve storage efficiencies? (Choose three.)
A. compression
B. encryption
C. compaction
D. ADP
E. thin provisioning
Answer: ACE
Question #9 (Topic: Single Topic)
You are working on a fabric MetroCluster. After a site failure, the plex starts to resync automatically to the aggregate mirror of Aggr1. The plex now shows a status
of resyncing. During this process, you experience a slow resync of the SyncMirror plex.
In this scenario, how do you solve the problem?
of resyncing. During this process, you experience a slow resync of the SyncMirror plex.
In this scenario, how do you solve the problem?
A. Add more disks to the aggregate to add more I/O capacity.
B. Destroy and re-create plex, then run a baseline sync.
C. Tune the resync speed by adding a QoS policy and limit the concurrent I/O to the aggregate.
D. Tune the resync speed using the storage raid-options command.
Answer: D
Question #10 (Topic: Single Topic)
When you replace a motherboard, which step will completely test the newly installed component?
A. From ONTAP, execute sldiag.
B. From the LOADER prompt, type boot_ontap maint, then execute sldiag.
C. From the LOADER prompt, type boot_diags, then execute sldiag.
D. From the LOADER prompt, execute sldiag.
Answer: C
