Netapp NS0-094 - NetApp Hardware Support Engineer Professional Exam
Page: 2 / 12
Total 60 questions
Question #6 (Topic: Exam A)
After you configure a new interface group with ports e2a and e2b, the ports are showing as down in the interface group.
Which two actions correct the issue? (Choose two.)
Which two actions correct the issue? (Choose two.)
A. Verify the switch side LACP configuration.
B. Add the ports e2a and e2b to broadcast domain bd_data1.
C. Modify ports e2a and e2b to -autonegotiate-admin false -speed-admin 40000.
D. Ensure that the switch ports are correctly cabled.
Answer: AD
Question #7 (Topic: Exam A)
A customer replaced a data switch, and NetApp ONTAP software is showing the following output:
Why is the port shown as degraded after creating the VLAN?
Why is the port shown as degraded after creating the VLAN?
A. The port is not a member of the failover group for this VLAN.
B. The interface group (ifgroup) is configured as active/standby.
C. The VLAN is not configured on the connected data switch port.
D. The connected data switch port is in a shutdown state.
Answer: C
Question #8 (Topic: Exam A)
You have a NetApp ONTAP cluster that is serving both SMB over 10Gbe and FC data. An application owner has started to complain about poor performance and asks you to research the issue. When looking through EMS messages, you see the following output:
Which defective component triggers the EMS message?
Which defective component triggers the EMS message?
A. 10Gbe module
B. fiber cable
C. 32G FC module
D. adapter card in slot 2
Answer: C
Question #9 (Topic: Exam A)
You are troubleshooting an L2 connectivity problem, and you want to analyze network traffic.
Which command do you use to capture network packets?
Which command do you use to capture network packets?
A. traceroute
B. netstat
C. ping
D. tcpdump
Answer: D
Question #10 (Topic: Exam A)
While setting up a replication between two clusters, an administrator receives the following error message:
Failed to create cluster peering with ‘Error: RPC to peer address 192.168.31.10 failed’.
What is the cause of this issue?
Failed to create cluster peering with ‘Error: RPC to peer address 192.168.31.10 failed’.
What is the cause of this issue?
A. The cluster interconnect cables are faulty or have been disconnected.
B. The nodes are running incompatible versions of NetApp ONTAP software.
C. A license has expired or is invalid for one of the nodes.
D. A firewall is blocking necessary communication ports.
Answer: D
