Juniper JN0-682 - Data Center, Professional (JNCIP-DC) Exam
Page: 3 / 20
Total 97 questions
Question #11 (Topic: Exam A)
Which IP fabric underlay protocol provides the highest degree of scalability?
A. IS-IS
B. RIP
C. BGP
D. OSPF
Answer: A
Question #12 (Topic: Exam A)
You are asked to increase the overall throughput of an existing IP fabric.
Which two tasks would accomplish this goal? (Choose two.)
Which two tasks would accomplish this goal? (Choose two.)
A. Add one more leaf node to the fabric.
B. Add one uplink to all existing spine nodes from the newly added leaf node.
C. Add one more uplink from each leaf node to the newly-added spine node.
D. Add one more spine node to the fabric.
Answer: AD
Question #13 (Topic: Exam A)
You have a two spine and a four leaf CRB topology and you want to ensure the hosts connected to the leaf devices have reachability to all local spine IRB interface addresses.
Which configuration parameters must be used to accomplish this task?
Which configuration parameters must be used to accomplish this task?
A. Configure proxy-macip-advertisement under the IRB interface.
B. Configure a spine-to-spine EVPN peering as part of the routing instance.
C. Configure a spine-to-spine BGP peering as part of the overlay.
D. Configure virtual-gateway-accept-data under the IRB interface.
Answer: C
Question #14 (Topic: Exam A)
You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF, however, the traffic is not reaching service L2.
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (Choose two.)
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (Choose two.)
A. Ensure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.
B. Ensure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.
C. Examine the INSPECT-VRF.inet.0 route table on L1 for a default route that will direct the traffic to L2.
D. Examine the INSPECT-VRF.evpn.0 route table on L1 for a default route that will direct the traffic to L2.
Answer: AB
Question #15 (Topic: Exam A)
A VXLAN has been created between devices leaf1 and leaf3.
Referring to the exhibit, which statement is true?
A. Traffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting leaf3.
B. Traffic sent from host1 to host2 will be dropped on leaf1.
C. Traffic sent from host1 to host2 will be dropped on leaf3.
D. Traffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting leaf3.
Answer: D
