Juniper JN0-664 - Service Provider Routing and Switching, Professional (JNCIP-SP) Exam
Page: 3 / 20
Total 96 questions
Question #11 (Topic: Exam A)
Click the Exhibit button.
Referring to the exhibit, which two statements are true? (Choose two.)
Referring to the exhibit, which two statements are true? (Choose two.)
A. The multihop configuration is used for load balancing.
B. This route is learned from the same AS number.
C. This route is learned from two different AS numbers.
D. The multipath configuration is used for load balancing.
Answer: BD
Question #12 (Topic: Exam A)
A packet is received on an interface configured with transmission scheduling. One of the configured queues is exceeding the allocated bandwidth.
In this scenario, which two actions will be taken by default on a Junos device? (Choose two.)
In this scenario, which two actions will be taken by default on a Junos device? (Choose two.)
A. The exceeding queue will be considered to have negative bandwidth credit.
B. The excess traffic will be discarded.
C. The exceeding queue will be considered to have positive bandwidth credit.
D. The excess traffic will use bandwidth available from other queues.
Answer: BD
Question #13 (Topic: Exam A)
Which two statements are correct about a sham link? (Choose two.)
A. The PEs exchange Type 1 OSPF LSAs instead of Type 3 OSPF LSAs for the L3VPN routes.
B. It creates an OSPF multihop neighborship between two PE routers.
C. It creates a BGP multihop neighborship between two PE routers.
D. The PEs exchange Type 3 OSPF LSAs instead of Type 1 OSPF LSAs for the L3VPN routes.
Answer: AB
Question #14 (Topic: Exam A)
Click the Exhibit button.
R4 is directly connected to both RPs (R2 and R3). R4 is currently sending all joins upstream to R3 but you want all joins to go to R2 instead.
Referring to the exhibit, which configuration change will solve this issue?
R4 is directly connected to both RPs (R2 and R3). R4 is currently sending all joins upstream to R3 but you want all joins to go to R2 instead.
Referring to the exhibit, which configuration change will solve this issue?
A. Change the bootstrap priority on R2 to be higher than R3.
B. Change the local address on R2 to be higher than R3.
C. Change the default route in inet.2 on R4 from R3 as the next hop to R2.
D. Change the group-range to be more specific on R2 than R3.
Answer: A
Question #15 (Topic: Exam A)
Which two statements are correct regarding the PIM DR in a PIM-SM domain? (Choose two.)
A. By default. PIM DR election is performed on point-to-point links.
B. If the DR priorities match, the router with the lowest IP address is selected as the DR.
C. The source DR sends PIM register messages from the source network to the RP.
D. The receiver DR sends PIM join and PIM prune messages from the receiver network toward the RP.
Answer: CD
