HP HPE6-A85 - HPE Network Campus Access Associate Exam
Page: 2 / 12
Total 57 questions
Question #6 (Topic: Exam A)
When using an Aruba standalone AP you select “Native VLAN” for the Client VLAN Assignment.
In which subnet will the client IPs reside?
In which subnet will the client IPs reside?
A. The same subnet as the mobility conductor
B. The same subnet as the HPE Aruba Networking ESP gateway
C. The same subnet as the mobility controller
D. The same subnet as the access point
Answer: D
Question #7 (Topic: Exam A)
When performing live firmware upgrades on HPE Aruba Networking APs, which technology partitions all the APs based on RF neighborhood data, minimizing the impact on clients?
A. HPE Aruba Networking AI Insights
B. HPE Aruba Networking ESP
C. HPE Aruba Networking ClientMatch
D. HPE Aruba Networking AirMatch
Answer: D
Question #8 (Topic: Exam A)
What are the characteristics of VSF? (Choose two.)
A. VSF helps to simplify the network design by reducing the number of logical devices.
B. VSF forms virtual device by using proprietary stacking cables.
C. VSF-Stacks are limited to 7 members.
D. VSF forms a virtual device by using standard 10 Gbps/25 Gbps/50 Gbps ports.
E. VSF-Stacks are primarily used at the core layer.
Answer: AD
Question #9 (Topic: Exam A)
When would you bound multiple 20MHz wide 802.11 channels?
A. To decrease the Signal to Noise Ratio (SNR)
B. To provision highly available AP groups
C. To increase throughput between the client and AP
D. To utilize high gain omni-directional antennas
Answer: C
Question #10 (Topic: Exam A)
When using the OSFP dynamic routing protocol on an AOS-CX switch, what must match on the neighboring devices to exchange routes?
A. OSPF passive configuration
B. OSPF area
C. router-id
D. loopback configuration
Answer: B
