Page: 1
/ 6
Total 88 questions
Refer to the exhibit.
Which command will produce the above output?
- A. show interface vlan 1111
- B. show interface gigabit 1/1/1
- C. show vlan 1111
- D. show interface 1/1/1
Answer : D
DRAG DROP -
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.
Select and Place:
Answer :
Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?
- A. Aruba 8400
- B. Aruba 8408
- C. Aruba 6410
- D. Aruba 5412r
Answer : A
Reference:
https://packetpushers.net/aruba-8400-review-2/
What is the login and password combination is used when first configuring an Aruba OS-CX switch from factory defaults?
- A. Login admin and password admin.
- B. Login admin and password field empty.
- C. Login admin and password forgetme!.
- D. Login admin and password password.
Answer : B
Reference:
https://gzhls.at/blob/ldb/b/0/1/2/02b35c2be09e0616b7f0811d9306550f376f.pdf
What is the Link Layer Discovery Protocol?
- A. a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system
- B. a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4
- C. a standardized protocol for communicating directly-connected device information and capabilities.
- D. an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP
Answer : C
HOTSPOT -
Click on the colored box that corresponds with the line that best represents Multicast traffic flow.
Hot Area:
Answer :
Explanation:
Blue Box -
Refer to the exhibit.
What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit below?
- A. Access-1(config)# interface 1/1/1 Access-1(config-if)# routing Access-1(config-if)# interface vlan 100 Access-1(config-if-vlan)# ip address 10.1.1.1/24
- B. Access-1(config)# interface 1/1/1 Access-1(config-if)# vlan trunk permit vlan 100 Access-1(config-if)# interface vlan 100 Access-1(config-if-vlan)# ip address static 10.1.1.1/24
- C. Access-1(config)# interface vlan 100 Access-1(config-if-vlan)# ip address 10.1.1.1/24
- D. Access-1(config-if)# vlan 100 Access-1(config-vlan)# ip address 10.1.1.1/24
Answer : C
HOTSPOT -
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.
Hot Area:
Answer :
Explanation:
Port 1/1/4 on Access-2.
What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)
- A. VPN access
- B. WAN/MPLS connectivity
- C. Endpoint Access
- D. Deep packet inspection
- E. Power over Ethernet
Answer : CE
Which network category applies to a SOHO internal network?
- A. SD-WAN
- B. LAN
- C. WAN
- D. Internet
Answer : D
The following command is issued:
Switch# checkpoint rollback start
What is the result?
- A. The command will fail because rollback commands must be issued from global-config mode.
- B. The switch will revert the running-configuration to the checkpoint called ג€startג€ without a reboot.
- C. The command will fail because it is incomplete.
- D. The switch will use the checkpoint ג€rollbackג€ as the starting configuration on next reboot.
Answer : B
Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)
- A. Aruba 6405
- B. Aruba 2930F
- C. Aruba 8400
- D. Aruba 5406R
- E. Aruba 8350
Answer : AC
Which two options are the Layer 2 protocols? (Choose two.)
- A. 802.1Q
- B. IPSec
- C. STP
- D. RIP
- E. 802.11af
Answer : AC
You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.
What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?
- A. checkpoint rollback 10
- B. checkpoint auto 10
- C. checkpoint auto confirm 10
- D. boot system secondary 10
Answer : B
Which Ethernet port combination does the Aruba 5400R ZL2 switch series support?
- A. 10/100 Megabit Ethernet, Gigabit Ethernet, and 100 Gigabit Ethernet
- B. Gigabit Ethernet, 25 Gigabit Ethernet, and 40 Gigabit Ethernet
- C. 10/100 Megabit Ethernet, Gigabit Ethernet, 25 Gigabit Ethernet, and 100 Gigabit Ethernet
- D. 10/100 Megabit Ethernet, Gigabit Ethernet, and 40 Gigabit Ethernet
Answer : D
Reference:
https://www.arubanetworks.com/assets/ds/DS_5400Rzl2SwitchSeries.pdf
30 days access 