Which type of SCSI error is a 0x801?
Answer : C
Which utility/command line collects the data needed to analyze a Brocade switch?
Answer : C
How many back-end activities have to occur when modifying a single sector on a RAID 5
LUN in a CLARiiON CX4 series array?
Answer : D
Click the Exhibit button.
In which slot is the iSCSI module installed?
Answer : C
Your customer has discovered that the boot images for both SPA and SPB in their CX3-80 are corrupt and will need re-imaging. The recovery image file was not loaded to the array during the last software upgrade.
What is the file extension for the "reactive" recovery file?
A. ENA -
B. MIF -
C. NDU -
D. PBU -
Answer : B Topic 1, B B
Which CX4 model supports SATA-II drives as vault drives?
Answer : A
What does the low priority, always running, Sniff Verify operation check?
Answer : C
Which type of session is required to reset the domain security to an established storage domain?
Answer : C
Which host failover software is supported with a Non-Disruptive Upgrade (NDU)?
Answer : A
How many power supplies/blower modules are needed to start mirrored write caching on a
CLARiiON CX4-480?
Answer : C
How is Write cache mirrored in a CLARiiON array?
Answer : D
Which information is used in the "Magic" 8 Bytes of a formatted sector of a degraded mode
RAID 1/0 group?
Answer : A
During a CLARiiON conversion the Upgrade Wizard does not start automatically when the
SP is booted to the Utility Partition.
What is the most common problem and resolution?
Answer : B
Your customer is serially connected using PPP from a management station to an array.
What is the maximum baud rate that can be used for a dial-up networking environment?
Answer : B
When does the PSM activate the new software on the secondary storage processor in a
Non-Disruptive Upgrade (NDU)?
Answer : D