Dell E20-260 - VPLEX Specialist Exam for Implementation Engineers Exam
Page: 1 / 42
Total 210 questions
Question #1 (Topic: )
A VPLEX administrator claims a 100GB Storage Volume that is thin provisioned on the
storage array and has 25GB physically allocated and creates a 1:1 encapsulated virtual
volume. After a local data mobility job for that Virtual Volume, the storage array
administrator notices that the allocated capacity has increased to 100GB. Why did this
happen?
storage array and has 25GB physically allocated and creates a 1:1 encapsulated virtual
volume. After a local data mobility job for that Virtual Volume, the storage array
administrator notices that the allocated capacity has increased to 100GB. Why did this
happen?
A. The destination Storage Volume was not claimed with the thin-rebuild parameter in VPLEX.
B. VPLEX does not support thin devices.
C. Neither the source nor the destination Storage Volume were claimed with the thin- rebuild parameter in VPLEX.
D. The source Storage Volume was not claimed with the thin-rebuild parameter in VPLEX.
Answer: A
Question #2 (Topic: )
How does VPLEX access back-end arrays?
A. Through Virtual Targets
B. Through Virtual Initiators
C. Through the front-end ports on the Management station
D. VPLEX provides storage through its own DAE(s)
Answer: B
Question #3 (Topic: )
Refer to the exhibit.
[EMC-E20-260-8.0/EMC-E20-260-3_2.png]
You are planning to perform data mobility between VPLEX Clusters using the GUI. What
mobility job options do you have?
[EMC-E20-260-8.0/EMC-E20-260-3_2.png]
You are planning to perform data mobility between VPLEX Clusters using the GUI. What
mobility job options do you have?
A. create, stop, activate, monitor, pause, throttle and terminate
B. create, activate, fracture, resync, monitor, pause, and commit
C. create, cancel, suspend, monitor, pause, throttle, and terminate
D. create, remove, cancel, monitor, pause, throttle, and commit
Answer: D
Question #4 (Topic: )
Refer to the exhibit.
[EMC-E20-260-8.0/EMC-E20-260-4_2.png]
Reference the message type shown at point "1".
What type of response will be sent back to the SNMP management server from the SNMP
Agent?
[EMC-E20-260-8.0/EMC-E20-260-4_2.png]
Reference the message type shown at point "1".
What type of response will be sent back to the SNMP management server from the SNMP
Agent?
A. A poll response containing requested data
B. A trap response containing requested data
C. A poll response that initiates a trap response
D. A trap response containing all MIB data
Answer: A
Question #5 (Topic: )
Which command script must be executed when upgrading a small VPLEX to medium
VPLEX?
VPLEX?
A. VPlexadmin add-engines
B. director add
C. VPlexadmin set
D. VPlexadmin add-directors
Answer: A
