Dell DES-1241 - Specialist - Platform Engineer, PowerStore Exam
Page: 1 / 12
Total 60 questions
Question #1 (Topic: Topic 1)
What describes Dell EMC PowerStore X front-end cabling?
A. Uses internal VMware virtual switching and does not require a management network
B. Storage and management use the same LACP bonded cable connection
C. Uses VLTi data switch interconnectivity to support vMotion networks
D. Management and discovery use the same cables and connections as storage
Answer: C
Question #2 (Topic: Topic 1)
Through which network do external hosts connect to the cluster for data access?
A. Management
B. ICM
C. ICD
D. Storage
Answer: D
Question #3 (Topic: Topic 1)
A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster.
What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?
What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?
A. All the needed management IP addresses for the new appliance must be pre-configured on the cluster
B. Additional appliance does not require a cluster management IP address
C. Additional appliance inherits all its management IPs from the existing appliance
D. All the needed management IP addresses for the new appliance are auto-generated by the cluster
Answer: D
Question #4 (Topic: Topic 1)
What describes the power requirements for Dell EMC PowerStore?
A. Lower model numbered systems require less AC line current than higher model numbered systems
B. T models require less total power than X models
C. X models require less total power than T models
D. Lower model numbered systems require less input voltage (VAC) than higher model numbered systems
Answer: A
Question #5 (Topic: Topic 1)
What is the last step when adding a drive to a Dell EMC PowerStore system?
A. Verify the new drive is seen
B. Add the drive to the pool
C. Backup the keystore
D. Zero the drive
Answer: A
