Axis Network Video Exam v6.3 (AX0-100)

Page:    1 / 10   
Total 145 questions

When using the AXIS Design Tool, what is the most important message to bring to your end user?

  • A. That the numbers calculated are always conservative
  • B. That using RAID configurations is always recommended
  • C. That redundant storage will more than double the calculations
  • D. That the calculations are only estimates and not final numbers


Answer : D

In a dark indoor environment one single Axis illuminator is available. At a distance of 1 m (3 ft 3 in) away from the illuminator the light intensity is 1024 lux. At what distance from the light source will the light intensity be 256 lux?

  • A. 2 m (6 ft 7 in)
  • B. 4m{13 ft 1 in)
  • C. 8 m (26 ft 3 in)
  • D. 16 m (52 ft 6 in)


Answer : A

What is the main purpose of the Arctic Temperature Control functionality?

  • A. To protect the camera electronics
  • B. To protect the camera mechanics
  • C. To protect the camera lens
  • D. To protect the camera power


Answer : B

Which of the following statements is a recommended best practice for outdoor installations of Axis cameras?

  • A. Connect cameras and end points (midspan, endspan. network switch or hub) with Category 5e UTP cable
  • B. Ensure that a surge suppressor is installed in front of each camera
  • C. Ensure that the end points are properly grounded
  • D. Connect a UPS to the network switch


Answer : C

Where is the best place to mount a camera with a fixed iris?

  • A. Outside, on a pole
  • B. Inside, in a room with large windows
  • C. Outside, in a shadowed position
  • D. Inside, in a room with very strong light sources


Answer : D

Focusing a camera improves the image, but it also

  • A. Has an effect on the frame rate
  • B. Increases the bandwidth
  • C. Changes the pixel resolution
  • D. Decreases the bandwidth


Answer : B

While setting up an AXIS Q7404 Video Encoder for control of an analog PTZ using Pelco D protocol, you run into a problem. After uploading of the proper Pelco drivers into the AXIS
Q7404 Video Encoder you find that channel 1 is controlling the wrong analog PTZ. Which option below would you adjust to fix this problem so you can avoid changing physical cables?

  • A. IP address
  • B. Device ID
  • C. Baud rate
  • D. Device type


Answer : B

When using HTTPS on Axis products, true security is implemented after the

  • A. 64 character password is in place.
  • B. 256 character password is in place.
  • C. MAC address filtering is activated.
  • D. Signed certificate is installed.


Answer : D

To make use of IEEE 802.1 X when connecting a camera to the network, you need
(Choose two)

  • A. An Ethernet switch with support for IEEE 802.1X.
  • B. A router.
  • C. A RADIUS server.
  • D. Category 6 or Category 5e Ethernet cabling.
  • E. A server with a Gigabit Ethernet network card.


Answer : A,C

IEEE 802.1 X is a security feature that

  • A. Applies end-to-end encryption between the camera and the server over the internet, ensuring that other users on the network cannot eavesdrop on the surveillance video.
  • B. Only gives approved devices access to the network, making it impossible to disconnect a camera and connect other equipment to eavesdrop on the network.
  • C. Disables port forwarding, making it impossible for users outside the local network to get access to the surveillance video.
  • D. Uses a cryptographic signature to ensure the integrity of the address tables used by the router, making it impossible for malicious users to redirect the surveillance video to unauthorized recipients.


Answer : B

In a network surveillance installation, the purpose of a router is to

  • A. Forward the video stream between networks.
  • B. Forward the video stream to the correct receiver within a network.
  • C. Separate audio and video traffic to reduce audio latency.
  • D. Separate the video stream from the camera control signaling.


Answer : A

Which statements on Group of video (GOV) length are true? (Choose two)

  • A. The GOV length can be adjusted in both Motion JPEG and H.264
  • B. The GOV length setting only has an impact on MPEG-4
  • C. The GOV length setting is only used for recording
  • D. The GOV length setting has an impact on bandwidth
  • E. A long GOV length increases the storage time on SD card


Answer : D,E

Which is an advantage of the H.264 compression standard?

  • A. Bandwidth and storage usage is independent of the amount of motion in the video
  • B. Compared to Motion JPEG. H.264 video reduces the CPU load when viewing the video
  • C. In most situations, compared to Motion JPEG. H.264 video reduces bandwidth and storage usage
  • D. The intra-frame coding makes the video less sensitive to network dropouts


Answer : C

Working with a retailer on a site survey, they ask if there's any way to get more of the aisle and less of the shelves on the short sides in the shot. An AXIS M3204 camera is being used. Which would be the best suggestion to the retailer?

  • A. Adjusting the varifocal lens from 2.8 mm to 10 mm
  • B. Adjusting the varifocal lens from 2.8 mm to 4 mm
  • C. Using Axis' Corridor Format
  • D. Switching the camera to a 16:9 view


Answer : C

An analog system that should be upgraded to IP using encoders must have the end of the analog signal terminated. How many Ohm () should that be?

  • A. 50
  • B. 70
  • C. 75
  • D. 80


Answer : C

Page:    1 / 10   
Total 145 questions