Cisco 500-260 - Cisco ASA Express Security (SAEXS) Exam
Page: 1 / 10
Total 50 questions
Question #1 (Topic: )
Which option is correct for configuring the SRF for passive, out-of-band traffic evaluation?
A. sfr fail-close oob
B. sfr monitor-only
C. sfr fail-open monitor-only
D. sfr passive-mode
Answer: B
Question #2 (Topic: )
Which impact flag indicates that action is to be taken immediately?
A. 0
B. 1
C. 5
D. 4
Answer: B
Question #3 (Topic: )
Refer to the exhibit.
[Cisco-500-260-6.0/Cisco-500-260-2_2.png]
Which Cisco ASA CLI commands configure these static routes in the Cisco ASA routing
table?
[Cisco-500-260-6.0/Cisco-500-260-2_2.png]
Which Cisco ASA CLI commands configure these static routes in the Cisco ASA routing
table?
A. route dmz 10.2.2.0 0.0.0.255 172.16.1.10 route dmz 10.3.3.0 0.0.0.255 172.16.1.11
B. route dmz 10.2.2.0 0.0.0.255 172.16.1.10 1 route dmz 10.3.3.0 0.0.0.255 172.16.1.11 1
C. route dmz 10.2.2.0 0.0.0.255 172.16.1.10 route dmz 10.3.3.0 0.0.0.255 172.16.1.11 2
D. route dmz 10.2.2.0 255.255.255.0 172.16.1.10 route dmz 10.3.3.0 255.255.255.0 172.16.1.11
E. route dmz 10.2.2.0 255.255.255.0 172.16.1.10 1 route dmz 10.3.3.0 255.255.255.0 172.16.1.11 1
F. route dmz 10.2.2.0 255.255.255.0 172.16.1.10 route dmz 10.3.3.0 255.255.255.0 172.16.1.11 2
Answer: F
Question #4 (Topic: )
An SFR module has been installed in the adaptive security appliance. Which command
must be executed on the module to establish connectivity to FireSIGHT Management
Center?
must be executed on the module to establish connectivity to FireSIGHT Management
Center?
A. system install manager
B. config manager fmc host
C. config manager add
D. system manager fmc
Answer: B
Question #5 (Topic: )
Which Cisco ASA CLI command is used to enable HTTPS (Cisco ASDM) access from any
inside host on the 10.1.16.0/20 subnet?
inside host on the 10.1.16.0/20 subnet?
A. http 10.1.16.0 0.0.0.0 inside
B. http 10.1.16.0 0.0.15.255 inside
C. http 10.1.16.0 255.255.240.0 inside
D. http 10.1.16.0 255.255.255.255
Answer: C
