Cisco 500-202 - Implementing Cisco Service Provider Mobile Unlicensed Small Cell Solutions Exam
Page: 3 / 11
Total 51 questions
Question #11 (Topic: )
To improve the user experience, Cisco Service Provider Wi-Fi networks should use
authentication options that automate user authentication and no longer require the user to
enter their credentials manually.
Which two authentication methods automate user authentication? (Choose two.)
authentication options that automate user authentication and no longer require the user to
enter their credentials manually.
Which two authentication methods automate user authentication? (Choose two.)
A. web (portal) login
B. EAP-AKA
C. EAP-FAST
D. EAP-SIM
Answer: B,D
Question #12 (Topic: )
Which option is a requirement for a client when PMIPv6 is used in the Cisco Service
Provider Wi-Fi environment?
Provider Wi-Fi environment?
A. The client must be configured to support IPv6 and be assigned an IPv6 address.
B. The client must be connected to the MAG through an IPv4-over-IPv6 tunnel.
C. The client must run a dual-stack, that is, have both an IPv4 and an IPv6 address assigned to it.
D. There are no special requirements for the client.
Answer: D
Question #13 (Topic: )
Which three ways can be used to configure a wireless controller? (Choose three.)
A. the AutoInstall process
B. the AutoTune feature on an ISG
C. automatic provisioning by CNR
D. configuration push from CPI
E. manual configuration via web GUI or CLI
F. configuration downloaded from TR69 server
Answer: A,D,E
Question #14 (Topic: )
How does 802.11r or fast BSS transition reduce the amount of time required for a client to
roam?
roam?
A. by allowing a client to pre-associate to multiple APs, which eliminates the need for the client to associate to a new AP when roaming
B. by giving a new client priority in the AP scheduling mechanism, which gives a new client a faster response from the new AP
C. by reducing the amount of authentication messaging between a client and a new AP, which means that the client does not need to renegotiate keys with the new AP
D. by adding hand-off communications between the APs, which means that the old AP notifies the new AP when the client is about to roam
Answer: C
Question #15 (Topic: )
Which two benefits does IEEE 802.11k "Radio Resource Management" provide to a Wi-
Fi network? (Choose two.)
Fi network? (Choose two.)
A. If an AP is not servicing any wireless clients, it can shut itself down until it is put back into service by the wireless controller.
B. A client can look at parameters other than signal strength to determine which AP to associate to.
C. An AP can cause a dual-band client to prefer the 5 GHz 802.11a/n spectrum over the more-crowded 2.4 GHz 802.11b/g/n spectrum.
D. An overloaded AP can direct a client to switch from it to another AP in the network.
Answer: B,D
