Cisco 352-001 - CCDE™ Written Exam (v2.1) Exam
Page: 3 / 101
Total 501 questions
Question #11 (Topic: Topic 1)
Which two mechanisms can provide fast Layer 2 down detection in Frame Relay networks?
(Choose two.)
(Choose two.)
A. asynchronous LMI
B. millisecond LMI timers
C. A-bit signaling
D. Frame BFD Lite
E. section 9 LMI convergence
Answer: A,C
Question #12 (Topic: Topic 1)
Refer to the exhibit.
[Cisco-352-001-13.0/Cisco-352-001-9_2.png]
Will traffic sourced from router A and destined for a host on network 10.1.1.0/24 always
take the optimal path to that host?
[Cisco-352-001-13.0/Cisco-352-001-9_2.png]
Will traffic sourced from router A and destined for a host on network 10.1.1.0/24 always
take the optimal path to that host?
A. No, if router A chooses to forward traffic destined to a host on the 10.1.1.0/24 network to router B, it will take a less than optimal path to reach its destination.
B. Yes, router A has enough information to always direct traffic to router C when forwarding traffic to a host on the 10.1.1.0/24 network.
C. Yes, router B will forward the traffic towards 10.1.1.0/24 correctly, if router A chooses that path.
D. It doesn't matter which path to a host on 10.1.1.0/24 router A chooses, through router B or router C, since they are equal in cost.
E. It depends on the routing protocol.
Answer: A
Question #13 (Topic: Topic 1)
Company X will be integrating an IPv6 application into their network and wants to develop a
test environment to evaluate application performance across the network. This application
will require both unicast and multicast communications. The company can do this
implementation only in certain areas of its existing IPv4-only network, but wants all areas to
communicate with each other. When developing the design to provide connectivity between
these testing locations, what tunneling technology would work in this scenario?
test environment to evaluate application performance across the network. This application
will require both unicast and multicast communications. The company can do this
implementation only in certain areas of its existing IPv4-only network, but wants all areas to
communicate with each other. When developing the design to provide connectivity between
these testing locations, what tunneling technology would work in this scenario?
A. ISATAP
B. 6to4
C. DMVPN
D. 6vPE
E. 6PE
Answer: C
Question #14 (Topic: Topic 1)
A metro service provider is planning Resilient Ethernet Protocol for his backbone. Which
two aspects must be considered before the network design is finalized? (Choose two.)
two aspects must be considered before the network design is finalized? (Choose two.)
A. Two Resilient Ethernet Protocol segments can be connected redundantly at two points. One connection will be blocked, using the Spanning Tree Protocol defined in IEEE 802.1D.
B. UniDirectional Link Detection Protocol can be enabled on Resilient Ethernet Protocol interfaces to detect unidirectional failures.
C. The guaranteed convergence recovery time is less than 50 ms for the local segment.
D. A Resilient Ethernet Protocol segment is limited to a maximum of seven devices.
E. VLAN load balancing for optimal bandwidth usage is supported in any Resilient Ethernet Protocol segment.
Answer: B,E
Question #15 (Topic: Topic 1)
When creating a network design, which one of these options provides for basic Layer 2
client isolation to
prevent broadcast traffic exposure?
client isolation to
prevent broadcast traffic exposure?
A. SVI
B. VLAN
C. routed port
D. edge port
Answer: B
