Cisco 300-615 - Troubleshooting Cisco Data Center Infrastructure (DCIT) Exam
Page: 2 / 50
Total 247 questions
Question #6 (Topic: Single Topic)
Refer to the exhibit. The HSRP configuration in the exhibit fails to function. Which action resolves this issue?
A. Enable IP redirects.
B. Set the MTU to 1500 bytes.
C. Configure HSRP version 2.
D. Configure the same HSRP group on both devices.
Answer: C
Question #7 (Topic: Single Topic)
Refer to the exhibit. The HSRP instance on both switches is showing as active. Which action resolves the issue?
A. Configure the HSRP timers to be the same.
B. Allow VLAN 100 between the switches.
C. Configure the IP address of N9K-B on the same subnet as N9K-A.
D. Configure preempt on only one of the switches.
Answer: B
Question #8 (Topic: Single Topic)
An engineer troubleshoots a fabric discovery failure. Which two requirements about switch connectivity must be verified to solve the problem? (Choose two.)
A. A Cisco APIC must be attached to a spine node only.
B. A Cisco APIC must be attached to leaf nodes.
C. Spine nodes must connect to other spine nodes.
D. A Cisco APIC must be dual-attached to two separate spine nodes.
E. Leaf nodes must connect to spine nodes only.
Answer: BE
Question #9 (Topic: Single Topic)
Refer to the exhibit. A network engineer connects the Cisco Nexus switch management port to the Internet using DHCP to allow the Guest shell that runs on the
switch to download Python packages. The engineer can ping google.com from the Cisco Nexus switch, but the Guest shell fails to download Python packages.
Which action resolves the problem?
A. Update the Python packages directly on the Cisco Nexus switch.
B. Manually configure DNS in the Guest shell, even if it is claimed on the Cisco Nexus switch through DHCP.
C. Manually configure NTP in the Guest shell.
D. Connect Guest shell to data plane interfaces to be able to connect to the networks outside of the Cisco Nexus switch.
Answer: B
Question #10 (Topic: Single Topic)
Refer to the exhibit. The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)
A. Match the vPC domain ID between the two devices.
B. Configure the IP address on the interface.
C. Activate VLANs on the vPC.
D. Correct the configuration of the vPC peer link and the vPC peer keepalive.
E. Configure one of the switches as primary for the vPC.
Answer: AC
