Cisco 300-365 - Deploying Cisco Wireless Enterprise Networks Exam
Page: 1 / 13
Total 61 questions
Question #1 (Topic: )
You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this
VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0
firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly,
but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot
place calls. What is the issue?
VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0
firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly,
but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot
place calls. What is the issue?
A. The lowest mandatory speed in the WLAN is too high and needs to be reduced.
B. The Cisco Unified Wireless IP Phones 7920G and Nokia IP phones do not support TSPEC.
C. EDCA needs to be enabled on the WLAN.
D. HCCA needs to be enabled on the WLAN.
E. The reserved roaming bandwidth setting is set too low.
F. The expedited bandwidth setting needs to be enabled.
Answer: B
Question #2 (Topic: )
Scenario
One of your colleagues has setup a test network in the lab to simulate a new building atone
of your regional offices. Your team is testing AP failover. Your colleague has requested you
to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs
will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs
on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the
higher-priority AP and if necessary disassociates a lower-priority AP to provide access to
an available port.
Not all menus, tabs and features are supported.
Topology
[Cisco-300-365-7.0/Cisco-300-365-3_2.png]
[Cisco-300-365-7.0/Cisco-300-365-3_3.png]
[Cisco-300-365-7.0/Cisco-300-365-3_4.png]
[Cisco-300-365-7.0/Cisco-300-365-3_5.png]
[Cisco-300-365-7.0/Cisco-300-365-4_2.png]
[Cisco-300-365-7.0/Cisco-300-365-4_3.png]
One of your colleagues has setup a test network in the lab to simulate a new building atone
of your regional offices. Your team is testing AP failover. Your colleague has requested you
to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs
will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs
on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the
higher-priority AP and if necessary disassociates a lower-priority AP to provide access to
an available port.
Not all menus, tabs and features are supported.
Topology
[Cisco-300-365-7.0/Cisco-300-365-3_2.png]
[Cisco-300-365-7.0/Cisco-300-365-3_3.png]
[Cisco-300-365-7.0/Cisco-300-365-3_4.png]
[Cisco-300-365-7.0/Cisco-300-365-3_5.png]
[Cisco-300-365-7.0/Cisco-300-365-4_2.png]
[Cisco-300-365-7.0/Cisco-300-365-4_3.png]
Answer: Pending
Question #3 (Topic: )
An engineer would like to capture NetFlowdata on PI. Which resource is required to allow
this?
this?
A. Cisco MSE as NetFlow exporter
B. Prime Infrastructure 1.0 or later
C. Cisco NAC as NetFlow exporter
D. Cisco ISE as NetFlow exporter
Answer: B
Question #4 (Topic: )
A customer has implemented a N+1 high availability plan in a multistory building. All APs
on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors
are set as primary to WLC-8. Which two problems are likely to arise from this design?
(Choose two)
on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors
are set as primary to WLC-8. Which two problems are likely to arise from this design?
(Choose two)
A. inconsistent CleanAir data due to multiple WLCs
B. floor-to-floor bleed-through that causes intercontroller roaming delays
C. AVC inconsistency due to multiple mobility group members
D. legacy device compatibility with multiple WLC configuration that causes disconnects
E. unpredictable AP loading during a WLC failure
Answer: A,C
Question #5 (Topic: )
Drag the QoS values from the left and drop them in the correct descending order of priority
on the right.
[Cisco-300-365-7.0/Cisco-300-365-5_2.png]
on the right.
[Cisco-300-365-7.0/Cisco-300-365-5_2.png]
Answer: [Cisco-300-365-7.0/Cisco-300-365-6_2.png]
