Cisco 300-110 - Designing Cisco Wireless Networks (WLSD) Exam
Page: 2 / 12
Total 58 questions
Question #6 (Topic: Topic 1, Wireless Site Survey
)
An engineer must produce a passive survey report. The coverage heat map shows the entire site with all signal levels.
To see only the desired coverage, which action must the engineer take?
To see only the desired coverage, which action must the engineer take?
A. Change the color scheme to show the desired heat map.
B. Use the RSSI slider to set the heat map to the desired cutoff filter.
C. Filter the results to show the desired APs only.
D. Use the RSSI calibration tool to configure the receiver sensitivity.
Answer: B
Question #7 (Topic: Topic 1, Wireless Site Survey
)
Why is Wi-Fi 7 client connectivity reduced in an X-ray room?
A. X-rays within these rooms cause multipath issues.
B. X-ray rooms exhibit increased signal attenuation.
C. X-rays create significant non-Wi-Fi interference on the 802.11a band.
D. X-rays impact the 802.11a UNII-2 channels that cause APs to dynamically change channels.
Answer: B
Question #8 (Topic: Topic 1, Wireless Site Survey
)
Refer to the exhibit.
A wireless consultant is performing an onsite survey using AirMagnet Survey PRO.
What must be configured on the floor map so that the results appear properly?
A wireless consultant is performing an onsite survey using AirMagnet Survey PRO.
What must be configured on the floor map so that the results appear properly?
A. Add inter-floor bleed.
B. Show details of the user density.
C. Calibrate the dimensions.
D. Display details of the desk numbers.
Answer: C
Question #9 (Topic: Topic 1, Wireless Site Survey
)
A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas.
Which two elements have a negative effect on the wireless users? (Choose two.)
Which two elements have a negative effect on the wireless users? (Choose two.)
A. client authentication
B. access point height
C. wireless channels
D. client authorization
E. absorption
Answer: BE
Question #10 (Topic: Topic 1, Wireless Site Survey
)
Where must the APs be mounted when used in a high-density wireless network to provide 6 dB to 20 dB of attenuation to a cell?
A. under the seat
B. in the aisle
C. under the stage
D. above the stage
Answer: A
