Cisco 300-101 - CCNP Implementing Cisco IP Routing (ROUTE v2.0) Exam
Page: 3 / 170
Total 846 questions
Question #11 (Topic: Network Principles)
A network administrator uses IP SLA to measure UDP performance and notices that packets on one router have a higher one-way delay compared to the opposite
direction. Which UDP characteristic does this scenario describe?
direction. Which UDP characteristic does this scenario describe?
A. latency
B. starvation
C. connectionless communication
D. nonsequencing unordered packets
E. jitter
Answer: A
Question #12 (Topic: Network Principles)
Under which condition does UDP dominance occur?
A. when TCP traffic is in the same class as UDP
B. when UDP flows are assigned a lower priority queue
C. when WRED is enabled
D. when ACLs are in place to block TCP traffic
Answer: A
Question #13 (Topic: Network Principles)
Which difference in the packet fragmentation feature between IPv4 and IPv6 devices is true?
A. Only IPv6 headers support the DF bit.
B. Only IPv6 packets can be fragmented at the destination.
C. Only IPv4 headers support the more fragments bit.
D. Unlike IPv4 routers, IPv6 routers cannot fragment packets by default.
Answer: D
Question #14 (Topic: Layer 2 Technologies)
Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?
A. Disable CDP on the interface.
B. Execute the vpdn enable command.
C. Execute the no switchport command.
D. Enable QoS FIFO for PPPoE support.
Answer: B
Question #15 (Topic: Layer 2 Technologies)
A network engineer has been asked to ensure that the PPPoE connection is established and authenticated using an encrypted password. Which technology, in
combination with PPPoE, can be used for authentication in this manner?
combination with PPPoE, can be used for authentication in this manner?
A. PAP
B. dot1x
C. Ipsec
D. CHAP
E. ESP
Answer: D
