Cisco 200-125 - CCNA Cisco Certified Network Associate Exam
Page: 2 / 246
Total 1228 questions
Question #6 (Topic: Network Fundamentals)
What are two benefits of private IPv4 IP addresses? (Choose two.)
A. They are routed to the Internet the same as public IP addresses.
B. They are less costly than public IP addresses.
C. They can be assigned to devices without Internet connections.
D. They eliminate the necessity for NAT policies.
E. They eliminate duplicate IP conflicts.
Answer: BC
Question #7 (Topic: Network Fundamentals)
Which two server types are used to support DNS lookup? (Choose two.)
A. web server
B. ESX host
C. authoritative name server
D. file transfer server
E. name resolver
Answer: CE
Question #8 (Topic: Network Fundamentals)
Which three statements about IPv6 prefixes are true? (Choose three.)
A. FEC0::/10 is used for IPv6 broadcast.
B. FC00::/7 is used in private networks.
C. FE80::/8 is used for link-local unicast.
D. FE80::/10 is used for link-local unicast.
E. 2001::1/127 is used for loopback addresses.
F. FF00::/8 is used for IPv6 multicast.
Answer: BDF
Question #9 (Topic: Network Fundamentals)
Refer to the exhibit.
[Cisco-200-125-1.0/xmlfile-7_1.png]
The network administrator cannot connect to Switch 1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router.
Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on
Switch1 to correct this problem?
[Cisco-200-125-1.0/xmlfile-7_1.png]
The network administrator cannot connect to Switch 1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router.
Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on
Switch1 to correct this problem?
A. Switch1(config)# ip default-gateway 192.168.24.1
B. Switch1(config)# interface fa0/1 Switch1(config-if)# switchport mode trunk
C. Switch1(config)# line con0 Switch1(config-line)# password cisco Switch1(config-line)# login
D. Switch1(config)# interface fa0/1 Switch1(config-if)# ip address 192.168.24.3 255.255.255.0
E. Switch1(config)# interface fa0/1 Switch1(config-if)# duplex full Switch1(confiq-if)# speed 100
Answer: A
Question #10 (Topic: Network Fundamentals)
Which two statements about IPv6 and routing protocols are true? (Choose two.)
A. EIGRPv3 was developed to support IPv6 routing.
B. OSPFv3 was developed to support IPv6 routing.
C. Loopback addresses are used to form routing adjacencies.
D. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
E. Link-local addresses are used to form routing adjacencies.
Answer: BE
