SolarWinds Hybrid Cloud Observability Network Monitoring - Hybrid Cloud Observability Network Monitoring Exam
Page: 2 / 31
Total 151 questions
Question #6 (Topic: Exam A)
Flow data is not generating from a device in the web console. Wireshark was used to confirm the flows are being sent from the device to the poller and not blocked by the firewall. Why is the data not showing in the web console?
A. device is not monitored by hybrid cloud observability (HCO) features
B. device is using IPv6 and HCO only supports IPv4
C. missing source address field in flow configurations
D. flow monitoring was not enabled as device type in web console settings
Answer: C
Question #7 (Topic: Exam A)
Which two of the following tasks must be accomplished to monitor servers and connections in a load-balancing environment? (Choose two.)
A. add Cisco Nexus device in network device configuration manager
B. add Cisco Nexus device in network health / performance monitoring
C. enable CLI polling
D. enable F5 iControl polling
Answer: BD
Question #8 (Topic: Exam A)
What is a possible result of decreasing the top talking optimization value?
A. increased storage requirement
B. reduced database performance
C. reduced page load times
D. slower reporting speed
Answer: A
Question #9 (Topic: Exam A)
Which two of the following troubleshooting steps can be performed when a node is “up” and the data cannot be found in SolarWinds’ platform web console? (Choose two.)
A. Add a remote site node and make sure the firewall rules are configured to allow SNMP traffic.
B. Ping the device from the polling engine the device is assigned to using the command line.
C. Verify hardware health sensors on the device provide both status and values.
D. Wait ten minutes after a device is added to the console. Refresh the screen.
Answer: BD
Question #10 (Topic: Exam A)
Which tool can be used to display the physical layout of interfaces on graphical stencils?
A. device studio
B. device view
C. NetPath
D. network insight
Answer: B
