HP HPE7-A06 - HPE Aruba Networking Certified Expert - Campus Access Switching Exam
Page: 2 / 24
Total 116 questions
Question #6 (Topic: Exam A)
What is the best practice for using Dynamic Segmentation?
A. Use UBT to create isolated networks for specific types of devices.
B. Use a combination of role-based access and overlay technologies to create a layered security approach
C. Use LUR to assign roles to devices based on their location and DUR to assign roles to devices based on their user identity.
D. Use Dynamic Segmentation only on devices that are connected to the network via Wi-Fi.
Answer: B
Question #7 (Topic: Exam A)
A network administrator wants to collect dumps for traffic sources or destined to a specific IP address. What is the simplest diagnostic command or commands on AOS-CX switches to accomplish this?
A. diag utilities tcpdump source-destination-ip
B. diag utilities tcpdump host-ip
C. diag utilities tcpdump source-ip
diag utilities tcpdump destination-ip D. diag utilities tcpdump destination-ip
diag utilities tcpdump source-ip
diag utilities tcpdump destination-ip D. diag utilities tcpdump destination-ip
diag utilities tcpdump source-ip
Answer: B
Question #8 (Topic: Exam A)
You are implementing a network using Zero-Touch Provisioning (ZTP) to deploy the gateways. What are two requirements for the connection to the switchport? (Choose two.)
A. You must use port GE 0/0/1 on the gateway
B. The switchport needs to be untagged with Internet access
C. The switchport needs to be configured with IP address 172.16.0.254
D. Jumbo frames must be enabled
E. The gateway needs to be provided an IP address through DHCP
Answer: BE
Question #9 (Topic: Exam A)
A network administrator is implementing a new VoIP solution. They want the AOS-CX switches to advertise the correct DSCP priority for the physical IP phones.
Which switch features are needed to implement this solution? (Choose two.)
Which switch features are needed to implement this solution? (Choose two.)
A. LLDP med network-policy
B. Voice VLAN
C. LLDP med DSCP
D. LLDP dot3 mfs
E. Priority-Flow Control (PFC)
Answer: AB
Question #10 (Topic: Exam A)
The administrator pf a large company noticed that there are some problems with UCC sessions on a wired network. Some employees complain about dropped calls and poor quality. The administrator wants to monitor jitter on AOS-CX switches with IP SLA, but notices results spiking to 100%.
What should the administrator check first to correct monitoring to run as desired?
What should the administrator check first to correct monitoring to run as desired?
A. number of NAE agents
B. source IP and source port combination
C. memory and processor usage
D. CoPP settings
Answer: B
