Dell D-SNC-DY-00 - Dell SONiC Deploy Exam
Page: 2 / 9
Total 45 questions
Question #6 (Topic: Exam A)
Refer to the exhibit.
What is the purpose of the static route?
What is the purpose of the static route?
A. Provide a route to the 12.0.0.0 network.
B. Provide a route to the 192.168.45.0 network.
C. Verify that the 12.0.0.0 network is active and reachable.
D. Verify that devices in VLAN 45 are reachable.
Answer: A
Question #7 (Topic: Exam A)
What are three characteristics of VLAN translation? (Choose three.)
A. VLAN translation is not supported on MC-LAG port channel interfaces.
B. Trunk or access ports can be configured as members of any VLANs that are not used as an SVLAN.
C. By default, VLAN stacking is enabled on Z9432F-ON switches.
D. The SVLAN header is replaced with a VNI if the provider network uses a VXLAN overlay.
E. SVLAN configuration for both Q-in-Q VLAN tunneling and VLAN translation is possible on the same interface.
Answer: ADE
Question #8 (Topic: Exam A)
Refer to the exhibits.
PC1 has a valid address on the 192.168.10.0 network, and PC2 has a valid address on the 192.168.20.0 network. What happens when a ping command is issued between PC1 and PC2?
PC1 has a valid address on the 192.168.10.0 network, and PC2 has a valid address on the 192.168.20.0 network. What happens when a ping command is issued between PC1 and PC2?
A. The ping is successful because there is a route to 10.0.1.1, which is connected to 10.0.2.2, which is connected to PC2.
B. The ping is unsuccessful because there is no route to the VLAN 10 gateway address of 192.168.10.254.
C. The ping is successful because there are two routes from switch1 to switch2 which are connected to PC2.
D. The ping is unsuccessful because there is no route from switch 1 to the 192.168.20.0 network.
Answer: D
Question #9 (Topic: Exam A)
Refer to the exhibit.
Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40? (Choose three.)
Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40? (Choose three.)
A. Configure the access mode for the switch port.
B. Delete VLAN 40.
C. Shut down the relevant interface.
D. Remove the current access VLAN configuration.
E. Enter it into the relevant interface.
Answer: ADE
Question #10 (Topic: Exam A)
How many ports are in each port-group on the S5200 series switches?
A. 2
B. 6
C. 4
Answer: C
