CWNP CWAP-405 - Certified Wireless Analysis Professional Exam
Page: 1 / 12
Total 60 questions
Question #1 (Topic: Exam A)
Which Spectrum Analyzer plot would show the percentage of time a signal is measured at a particular frequency?
A. Duty Cycle
B. Real-Time FFT
C. Swept Spectrogram
D. Waterfall
Answer: B
Question #2 (Topic: Exam A)
Explain the protocol behavior that can be known in the following graphic?
A. Single Channel Architecture is in use.
B. The data frames are missing because the capture adaptor does not support the PHY rate being used to transmit the data.
C. Only the CTS frames are being acknowledged. This indicates a problem with the wireless client.
D. Only the CTS frames are being acknowledged. This is normal behavior.
Answer: A
Question #3 (Topic: Exam A)
You have been hired to troubleshoot a WLAN problem for a government organization. You intended to use a Protocol Analyzer as part of your troubleshooting methodology; however, the customer is concerned about you capturing sensitive data transmitted over the network. Which common protocol analyzer feature could you use to address this concern?
A. Forensics capture
B. Expert analysis
C. Data masking
D. Packet slicing
Answer: D
Question #4 (Topic: Exam A)
Your organization would like to give their network field engineers a tool to provide an overview of a given wireless LAN environment. They are interested in how many SSIDs are enabled per radio, channels used, and the number of APs per channel. They do not want to require the engineers to view multiple frames to determine the information. Which tool would you recommend that provides this information at the lowest cost?
A. Spectrum Analyzer
B. Protocol Analyzer
C. WLAN Scanner
D. Site Survey Software
Answer: C
Question #5 (Topic: Exam A)
You are troubleshooting an intermittent problem with some WLAN VoIP phones resulting in dropped calls. You configure your capture on a fixed channel matching the current operating channel of a test phone. So far, you have been unsuccessful in capturing the problem because the VoIP phone always roams to another AP before the problem occurs.
What would be the best setup for your packet capture to make sure you capture the problem?
What would be the best setup for your packet capture to make sure you capture the problem?
A. Determine which channel the phone is likely to roam to next and capture on that channel.
B. Configure the capture adaptor to scan all channels used in the environment.
C. Configure all APs in monitor mode and have the packets streamed back to your analyzer.
D. Use multiple capture adaptors and the channel aggregator feature of a protocol analyzer to capture on all AP channels in the client’s area.
Answer: D
