SPARC T4-Based Server Installation Essentials v6.0 (1z0-597)

Page:    1 / 5   
Total 77 questions

What is Critical Thread Optimization?

  • A. The ability to dynamically allocate core resources among active threads
  • B. The ability to bind individual threads to a processor
  • C. Part of the Processor Sets feature of Oracle Solaris that defines a group of logical processors and schedules threads on them.
  • D. Recognized by Oracle Solaris Scheduler as a thread that should run by itself on a single core

Answer : A

You have printed the partition(slice) informationfor a disk. What type of labeldoes it have?

  • A. SMI
  • B. EFI
  • C. e2label
  • D. xfs_admin

Answer : C

Which command lists dynamically reconfigurable hardware resources and shows their operational status?

  • A. dmesg
  • B. ldm ls
  • C. fmadm –al
  • D. cfgadm –al

Answer : D

Reference: step 2)

Using the logical domainconfiguration below,what is the domain and virtual CPU corresponding to physical CPU number 5?

  • A. domain primary, virtual CPU number 0
  • B. domain primary, virtual CPU number 1
  • C. domain ldg2, virtual CPU number 0
  • D. domain ldg1, virtual CPU number 1

Answer : D

After the Logical Domains Manager has been installed, what happens to the original system and instance of Oracle Solaris?

  • A. It becomes the control domain
  • B. It becomes the first guest domain
  • C. It is automatically configured as a service domain
  • D. Nothing Logical domains are created on top of the original instance of Oracle Solaris.

Answer : A

Reference: para on the page)

During an installation, you have selected two disks to be used for your ZFS root pool. What is the impact?

  • A. Only single disk configurations are supported for the root pool, so Solaris will use the current boot disk for the root pool.
  • B. Only single disk configurations are supported during the initial creation of a root pool. Mirrored pools can only be created after the initial installation.
  • C. A single ZFS volume will be used for the swap area and dump device.
  • D. A mirrored two disk configuration is set up for the root pool.

Answer : D

Reference: point
#3, second para)

In the OpenBoot PROM environment, you used theshow-children commandto list the physicaldrives on a specific RAID controller.Theoutput is below. Which command creates a
RAID0 volume with targets 9 and a?

  • A. 9 a create-raid0-volume
  • B. Create raid-volume = 0 9 a
  • C. 9 a create-raid-volume = 0
  • D. Create raid0-volume = 9 a

Answer : A

Reference: step

During the acclimatization process, what is the maximum positive or negative temperature gradient that is permitted for multi-layer boards?

  • A. Approximately 2° C (4° F) per hour
  • B. Approximately 4° C (7° F) per hour
  • C. Approximately 6° C (11° F) per hour
  • D. Approximately 8° C (4° F) per hour

Answer : A

If a fault includes a uuid and sunw-msg-id property, then the fault was detected by which of the following?

  • A. SunVTS
  • B. POST
  • C. Solaris Predictive Self-Healing
  • D. Oracle ILOM

Answer : C

Reference: 22, see the second row, second column of the table)

According to the Enterprise Installation Standards (EIS), what is the recommended minimum amount of memory that should be allocated to the control domain?

  • A. 2 GB
  • B. 3 GB
  • C. 4 GB
  • D. 6 GB

Answer : A

When sizing the /var partition on a UFS file system, you have estimated the /var/sadm area to have 20 GB. Why?

  • A. It is enough space to hold several complete crash dumps.
  • B. It is rough space to hold package and patch information.
  • C. It is enough space to hold logs and spools
  • D. It is identical to the space allocated for the root slice, which is 20 GB on this particular system.

Answer : D

System errorscan go undetected by the Oracle VTS test, since many are detected, managed, and reported by Oracle Solaris Predictive Self-Healing. What is one way to display these errors and faults?

  • A. Review the VTS error file
  • B. Review the output of fmdump
  • C. Review the system log files
  • D. Review the VTS kernel error log

Answer : D

A power supply fails on a SPARC T4-4 server and a replacement is not available. What should you do?

  • A. Remove the failed power supply immediately
  • B. Leave the failed power supply installed
  • C. Power down the server
  • D. Unconfigure the failed power supply

Answer : B

Reference: the note)

According to the Enterprise Installation Standards (EIS), what is the minimum amount of time SunVTS should be run?

  • A. 10 minutes
  • B. 20 minutes
  • C. 30 minutes
  • D. 1 hour

Answer : D

Which two tasks are required to install and configure Oracle VM Server for SARC
Management Information Base (MIB) software?

  • A. Install Oracle VM Server for SPARC MIB software on the primary and guest domains
  • B. Install Oracle VM Server for SPARC MIB software on the primary domain only
  • C. Load the Oracle VM Server for SPARC MIB module into the Oracle Solaris SMA
  • D. Load the Oracle VM Server for SPARC MIB module into the Oracle Solaris FMA

Answer : B,C

Page:    1 / 5   
Total 77 questions